Magnolia Plastics Magnobond 8001
Plastics for the Space Age Since 1957
Magnobond 8001, Single Component
DESCRIPTION
Magnobond 8001, is a single component silver-filled epoxy for chip bonding.
SPECIAL FEATURES
1. This system will "B Stage" through solvent evaporation to form a solid adhesive casting for bonding at a later time.
2. Magnobond 8001 has outstanding high purity characteristics.
3. The high electrical conductivity of 8001 remains essentially unchanged even after 200 hours at 200°C.
SPECIAL NOTE
Magnobond 8001 has excellent reflow properties from "B" stage and once cured has outstanding high temperature strength. In order to get the best hot strength it is important that the solvent be evaporated prior to bonding. Wet film thickness should be controlled to .005-.008 cm and "B" stage should be 30 minutes at 65°C. This schedule gets the solvent out without advancing the resin to the point of poor reflow.
PROPERTIES:
DANGER FIRST-AID
-------------------------------- -------------------------
May cause severe irritation. Eyes - Immediately flush
Do not get in eyes, on skin eyes with plenty of water
or clothing. for at least 15 minutes.
Do not inhale vapors. Get medical attention.
Wear rubber gloves & aprons. Skin - Wash immediately
Use with adequate ventilation. with soap and water.
Wash thoroughly after handling. Clothing - Remove clothing
For industrial use only. and wash before reuse.
Keep container closed.
Do not reuse this container.
Spec Sheet Dated: 07/25/85
For more information, contact us at:
Sales Division
Magnolia Plastics, Inc.
5547 Peachtree Industrial Boulevard
Chamblee, GA 30341-2296 USA
770-451-2777, Voice
770-451-5376, FAX
800-831-8031, Voice
Email: sales@magnapoxy.com
How To Order:
Doing Business with Magnolia Plastics
Return to Magnolia Plastics Home Page
Copyright © 1997, Magnolia Plastics, Inc. All Rights Reserved, including
the right of reproduction in whole or in part in any form. The stylized Magnolia Plastics logo is a
regsitered trademark of Magnolia Plastics, Inc.
Contact Magnolia at sales@magnapoxy.com
Updated: March 31, 1997
